Hydraulic
  

This line of elevators is ideal for low to mid-rise applications up to 7 floors with a maximum travel of 18200 mm. The speeds can range from 0.4 to 0.75 m/s. The preferred machine room location is at the lowest landing adjacent to the hoist way with a minimum size of 1850 mm. It is possible to locate the machine room remote from the hoist way and in many cases the machine room size can be altered.

   
      Hole less Hydraulic
 

The Hole less Hydraulic system eliminates the need for either a well hole or buried piping. The best application for the Hole less product is most any 2-story building with less than 14' of travel from one floor to the other. Its above-ground Hole less configuration responds effectively to the risk of soil and groundwater contamination, and greatly reduces environment concerns. This package-type unit is most practical for those 2-story buildings where handicap access is required.
This line of elevators is an economical solution for mid-rise buildings where bedrock, groundwater or existing walls make the drilling of a jack hole difficult. These elevators can serve up to 6 floors with maximum travel of 15000 mm. The speeds can range from 0.4 to 0.96 m/s. The preferred machine room location is at the lowest landing adjacent to the hoist way with a minimum size of 1850 mm x 1850 mm. It is possible to locate the machine room remote from the hoist way and in many cases the machine room size can be altered.

     
        Roped Hydraulic Passenger Elevator

This line of elevators is an economical solution for mid-rise buildings. The vertical loading on the building is minimized compared to traction elevators since the elevator is supported from below. Roped hydraulic elevators can serve up to 10 floors with a maximum travel of 25000 mm. The speeds can range from 0.4 to 0.75 m/s. The preferred machine room location is at the lowest landing adjacent to the hoist way with a minimum size of 1850 mm x 1850 mm. It is possible to locate the machine room remote from the hoist way and in many cases the machine room size can be altered.

   

   
 
 

Fig.1

Fig.2

Fig.3

Fig.4

Fig.5

Fig.6

Fig.7

Fig.8

Fig.9

   

Fig.10

 

 

Fig.11

Fig.12

   
          Lifting System with 2 indirect lateral pistons

       Fig .  1    Direct central piston

        Fig .  2   Multiple direct  pistons

       Fig .  3   Direct side- piston

       Fig .  4   Multiple direct side- piston

       Fig .  5   Indirect side- piston

       Fig .  6   Multiple indirect side- piston

       Fig .  7   Indirect Multi-pulley  side- piston

       Fig .  8   Multiple indirect side- pulley

       Fig .  9   Indirect  multi-pulley side- piston  with off-line pull

       Fig .  10  Multi-pulley on piston & cabin

       Fig .  11  Direct traction on piston

       Fig .  12  Pulley traction piston

 
   
 

 BF Elevator co

   

Tel : (9821) 879-0101    Fax : (9821) 879-3203

Powered by Piroozonline co